User's Manual

IMPORTANT: To ensure the proper operation of your Answering System:
1. Plug the AC ADAPTOR into the POWER - IN CONNECTION Jack.
2. Press and hold down the RESET button for 2 seconds at the back of the BASE
UNIT before initial use.
Setting the Day/Time Stamp
1. Day Setting
Press and hold down the button for 2
seconds then press the or button
to select the desired day setting. Press the
button again to accept the setting, and
then the LED Screen will display the hour
setting.
2. Hour Setting
Press the or button to select the
hour, then press the button to accept the
setting. The LED Screen will display the
minute setting.
3. Minute Setting
Press the or button to select the
desired minute, then press the button to
accept the setting.
NOTES:
1. The HANDSET and BASE UNIT clocks are independent from each other. Set the
HANDSET clock by following the time setting steps on page 23.
2. In case of power failure, reset the time setting on the BASE UNIT clock.
Recording Your Outgoing Messages
Your Answering System provides one PRIMARY MAILBOX and four individual MAILBOXES
(1, 2, 3, 4) which can receive their own Incoming Messages (ICM). Before using your Answering
System, it is suggested that you record an Outgoing Message (OGM). This is the announcement
callers will hear when the system answers a call.
A prerecorded system announcement “Please record your message after the beep” is available
if you choose not to record your own OGM.
Answering System Operation
Operation
vol+
play
s
k
i
p
r
p
t
m
e
m
o
code
P
a
g
e
I
n
U
s e
/
C
h
g
A
n
s
O
n
/
O
f
f
S
p
k
eras e
stop
vol-
time
ogm
m
1
m2 m3
m
4
S
p
k
A
n
s
O
n
/
O
f
f
30
time
time
time
skip
time
skip
skip
rpt
rpt
rpt
5860 man.qxd 11/7/2003 5:48 PM Page 39