User's Manual

Multi-HANDSET, Multi-BASE UNIT System Operation
Multi-HANDS
27
Multi-HANDSET, Multi-BASE UNIT System
The system supports the registration of 9 HANDSETS to BASE UNIT (B1). The user can add
another BASE UNIT (B2) and register the same HANDSETS. (NOTE: The BASE UNITS must
be connected to separate telephone lines.) The HANDSETS can make INTERCOM CALLS, and
CALL TRANSFERS to one another provided they are using the same BASE UNIT at that
time.
Intercom Call
1. With the HANDSET in STANDBY mode, press the
/INT button. The LCD Screen of the initiating
HANDSET will display “Select H/S:.”
2. Enter the ID # of the receiving HANDSET by
pressing the TELEPHONE KEYPAD to
buttons.
3. The receiving HANDSET will receive a page tone
and the LCD Screen will display “Handset #,
Paging You.”
4. The receiving HANDSET will connect by pressing
the /INT button. Both LCD Screens will display
“Intercom With:, Handset # .
5. To end the INTERCOM CALL, press the /INT
again. The LCD Screens of both HANDSET(S) will
return to STANDBY mode.
Receiving a Call while in Intercom Call
1. When an outside call is received, both HANDSETS
involved in the Intercom call will emit two short
double “beep” sounds. The Caller ID information, if
available, will display on the LCD Screens after the
alert “beep”.
2. Press the /INT button to terminate the intercom
call.
3. Press the button to access the outside call.
1
DEL
Initiating HANDSET
Initiating HANDSET
Receiving HANDSET
Both HANDSET
TALK
DEL
DEL
DEL
9
1
9
#
0
wxyz
5.8 dss
TALK
MENU RE/PA
EDI
T
D
EL
VO L SAVE
F
L
A
S
H
C
H
A
N
DIR/
ESC
2
abc
3
de f
6
mno
5
jkl
4
ghi
7
pqr s
8
tu v
3
2
5850 DSS man.qxd 11/18/2003 10:20 AM Page 34