User's Manual

AAA
AAA
AAA
AAA
Removing the BELT CLIP:
1. Pull the BELT CLIP LATCH away from the unit.
2. While pulling the BELT CLIP LATCH, push up on the BELT
CLIP to remove it from the unit, as shown in Figure 1.
Installing the BELT CLIP:
1. Slide the BELT CLIP into the BELT CLIP SLOT as shown
in Figure 2.
2. A “click” indicates the BELT CLIP is locked into position.
Getting StartedGetting Started
7 8
Carefully remove your COMMUNICATOR from its Blister
Pack. If there is any visible damage, do not attempt to
operate this COMMUNICATOR. Return it to the place of
purchase.
Figure 1
Figure 2
Battery Installation:
1. Remove the BELT CLIP. (Refer to “Removing the Belt Clip”
section.)
2. Remove the BATTERY COMPARTMENT COVER from the
BATTERY COMPARTMENT. See Figure 3.
3. Install 4 x 1.5V “AAA” alkaline batteries or Ni-MH
rechargeable batteries (not included) as shown.
4. Reinstall the BATTERY COMPARTMENT COVER and
lock the BATTERY COMPARTMENT COVER LATCH into
position. (Refer to “Installing the Belt Clip” section)
The COMMUNICATOR has a built in POWER
SAVER feature for maximum battery life. But when
the COMMUNICATOR is not being used, conserve
battery power by rotating the ON/OFF/VOLUME
CONTROL to OFF. Remove the batteries if the unit
will not be used for a long period of time.
Figure 3
Figure 4