Safety Information

ManualsBrandsLintelek ManualsActivity & Fitness TrackersFitness Tracker Heart Rate Monitor, Activity Tracker, Pedometer Watch with Connected GPS, Waterproof Calorie Counter, 14 Sports Modes Step Tracker for Women, Men and Gift

Page 44 of 57 Report No.: LCS210301193AS

IEC 62368-1

Clause

Requirement + Test

Result - Remark

Verdict

TRF No. IEC62368_1D

Shenzhen LCS Compliance Testing Laboratory Ltd.

Add: Room 101, 201, Building A and Room 301, Building C, Juji Industrial Park, Yabianxueziwei, Shajing Street, Bao'an District, Shenzhen,

Guangdong, China

Tel: +(86) 0755-8259 1330 | Fax：+(86) 0755-8259 1332 | E-mail：webmaster@lcs-cert.com | http:// www.lcs-cert.com

Circuit Location (x-y)

Operating

Condition

(Normal

/ Describe Single

Fault)

Measured

wattage or

During first

30 s (W / VA)

Measured

wattage or

After 30 s (W

/ VA)

Protective

Circuit,

Regulator, or

PTC Operated?

Yes / No

(Comment)

Resistive

PIS?

Yes/No

Supplementary Information:

A combination of voltmeter, VA and ammeter IA may be used instead of a wattmeter.

If a separate voltmeter and ammeter are used, the product of (VA x IA) is used to determine Resistive PIS

classification.

A Resistive PIS: (a) dissipates more than 15 W, measured after 30 s of normal operation, or (b) under single

fault conditions has either a power exceeding 100 W measured immediately after the introduction of the fault if

electronic circuits, regulators or PTC devices are used, or has an available power exceeding 15 W measured

30 s after introduction of the fault.

8.5.5

TABLE: High Pressure Lamp

N/A

Description

Values

Energy Source Classification

Lamp type .......................................................... :

—

Manufacturer ..................................................... :

—

Cat no. ............................................................... :

—

Pressure (cold) (MPa) ....................................... :

MS_

Pressure (operating) (MPa) .............................. :

MS_

Operating time (minutes) .................................. :

—

Explosion method ............................................. :

—

Max particle length escaping enclosure (mm) . :

MS_

Max particle length beyond 1 m (mm) .............. :

MS_

Overall result ..................................................... :

Supplementary information:

B.2.5

TABLE: Input test

U (V)

I (A)

I rated (A)

P (W)

P rated (W)

Fuse No

I fuse (A)

Condition/status

5.0Vdc

0.05

0.09

0.25

Empty battery charge

4.2Vdc

0.048

0.202

Battery discharging

and working normally

Supplementary information:

Equipment may be have rated current or rated power or both. Both should be measured