Safety Information

Page 25 of 57 Report No.: LCS210301193AS
IEC 62368-1
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC62368_1D
Shenzhen LCS Compliance Testing Laboratory Ltd.
Add: Room 101, 201, Building A and Room 301, Building C, Juji Industrial Park, Yabianxueziwei, Shajing Street, Bao'an District, Shenzhen,
Guangdong, China
Tel: +(86) 0755-8259 1330 | Fax：+(86) 0755-8259 1332 | E-mail：[e-mail] | http:// www.lcs-cert.com
G.3.3
PTC Thermistors
N/A
G.3.4
Overcurrent protection devices
N/A
G.3.5
Safeguards components not mentioned in G.3.1 to G.3.5
N/A
G.3.5.1
Non-resettable devices suitably rated and
marking provided
N/A
G.3.5.2
Single faults conditions ........................................ :
N/A
G.4
Connectors
N/A
G.4.1
Spacings
N/A
G.4.2
Mains connector configuration ........................... :
N/A
G.4.3
Plug is shaped that insertion into mains socket-
outlets or appliance coupler is unlikely
N/A
G.5
Wound Components
P
G.5.1
Wire insulation in wound components ................
N/A
G.5.1.2 a)
Two wires in contact inside wound component,
angle between 45° and 90°
N/A
G.5.1.2 b)
Construction subject to routine testing
N/A
G.5.2
Endurance test on wound components
N/A
G.5.2.1
General test requirements
N/A
G.5.2.2
Heat run test
N/A
Time (s) ............................................................... :

Temperature (C) ................................................ :

G.5.2.3
Wound Components supplied by mains
N/A
G.5.3
Transformers
N/A
G.5.3.1
Requirements applied (IEC61204-7, IEC61558-
1/-2, and/or IEC62368-1)..................................... :
N/A
Position ................................................................ :

Method of protection ........................................... :

G.5.3.2
Insulation
N/A
Protection from displacement of windings........... :

G.5.3.3
Overload test ...................................................... :
N/A
G.5.3.3.1
Test conditions
N/A
G.5.3.3.2
Winding Temperatures testing in the unit
N/A
G.5.3.3.3
Winding Temperatures – Alternative test method
N/A
G.5.4
Motors
P
G.5.4.1
General requirements
P
Position ............................................................... :
