Product Warranty
11
Time Lapse
To Capture a Time Lapse Series:
1. Verify the Connuous Lapse is ON.
2. Verify the camera is in Time Lapse mode .
3. Long press the Grey Video buon . The camera iniates a countdown and emits a
camera shuer sound each me a photo is taken
Drama Shot Photo
To Take a Burst Photo Series:
1. Verify the camera is in Drama Shot Photo mode (3PS, 5PS, 10PS).
2. Press the Red Photo buon . The camera will emit camera shuer sounds.
Replacing the Remote Battery
The remote uses a 3 Volt Lithium cell type CR3032.
• You will need a small jeweler’s screwdriver with a Philips or + p.
• Your working area should be a flat surface like a table or desk so you do not lose the
screws.
To replace the baery in the remote control:
1. Remove the non-buckle end of the strap.
2. Flip the Remote over so you can see the back cover.
3. Remove the 4 screws in each corner. Do not remove them completely because it will be
easier to put the cover back on and you will be less likely to lose a screw.
4. Set the cover to the side.
5. Push the baery sideway out of its holder using your fingernail or the p of the
screwdriver.
6. Slide in the new baery.
7. Put on the back cover.
8. Screw each screw back in. Tighten unl the screw driver jumps once. Do not overghten
9. Put the strap back through the re
mote.
10. Dispose of the lithium baery according to local, state or naonal regulaons.
SAFETY PRECAUTIONS
• Do not subject the device to severe impact or drop it from heights.
• Do not use the device in extreme hot or cold, dusty or damp conditions.
Do not expose it to direct sunlight.
• Avoid using the device near strong magnetic fields.
• Normal functioning of the product may be disturbed by ESD. If so,