Installation Sheet

Step 1: Depress the Spindle Retention
Spring inside the retention spring access
port at the Spindle's base. While
maintaining pressure on the spring, pull
the spindle from the lock's body.
*Note: If the spindle has not yet been
installed, skip to Step 2.
**Note: You will need a small object
(paper clip, screwdriver, punch, etc.) to
depress the spring.
Step 2: With the spindle removed, you will see a Phillips head screw inside of
the hole that the spindle was sitting in. Removing this screw will allow the
handle to come free from the lock's body - allowing you to set the orientation
of the lever.
Spindle
Retention
Spring
Retention
Spring Access
Port
Phillips
head
screw
for lever.
6
CHANGING THE LEVER DIRECTION
The Lever's factory setting is the RIGHT HAND setting. To change the direction of
the handle, please follow the following steps:
Lever
Front of
Panel
Lever
Screw
Step 3: With the lever in its desired position, Re-Install the lever's screw to
secure it into place.
Step 4: With the spindle retention spring depressed, place the spindle back into
the slot it was removed from. When the Retention Spring clicks into place inside of
the retention spring access port, you will know it is set into place and you are
finished.
Lever
Post
!
DISCLAIMER
Port Security is not
resoponsible for
any loss or damage
to the smartlock
that might occure
when not properly
following these
steps.