Installation Sheet

5. Attach the rubber gasket onto the back panel then attach the panel
onto the door with 3 screws.
4. Place the rubber gasket onto the back of the front panel and place
the front panel onto the door. The spindle will fit though the center slot
on the latch, with the left and right screw posts fitting though their
respected slots. The wire will flow through the smaller drilled hole.
9
6. Connect the cable (push any excess back into the hole it was pulled
through) and install the back panel. The back panel will slide onto the
spindle and the 4 screw posts. Install the 4 screws.