Quick Start Manual

8 5
The first Windows Vista Wireless A.
Network Configuration utility
screen appears. Select your
network, and then click Connect.
If your network has no wireless B.
security, this screen appears. If your
network has wireless security, go to
step C.
To connect to your unsecured
network, click Connect Anyway
and go to step E.
Enter the security key or passphrase C.
(also known as pre-shared key or
WEP key, depending on your type
of security).
Click Connect.
This screen appears while the D.
Adapter connects to your network.
Do not cancel, unless you want to
end the installation.
Setup for Windows Vista3
Select Network
Unsecured Network
Secured Network
Connecting to Network
The Available Wireless Networks screen appears. From this screen, you can launch
one of the two setup methods.
If your network appears on the Available Wireless Networks screen, continue with
this Quick Installation. If your network does not appear on the Available Wireless
Networks screen, click Advanced Setup and follow the on-screen prompts.
A. On the Available Wireless Networks
screen, the available networks
are listed in the table. Select your
network, and then click Connect.
If your network has no wireless security, you will be taken directly to the B.
Congratulations screen, shown in step C. If your network has wireless
security, you will see one of these wireless security screens. Follow the
instructions for the screen you see.
WPA2-Personal Needed for Connection
Enter the Pre-Shared Key of your 1.
wireless network. It must have 8-63
characters.
Click 2. Connect and go to step C.
Setup for Windows XP or 20002
Select Network
WPA2-Personal Needed for Connection