User Manual Part 7

ManualsBrandsLINKSYS ManualsComputers & AccessoriesWireless-G Broadband Router

Appendix C

Warranty and Regulatory Information

Wireless-G Broadband Router

Wireless Disclaimer

The maximum performance for wireless is derived from

IEEE Standard 802.11 specifications. Actual performance

can vary, including lower wireless network capacity,

data throughput rate, range and coverage. Performance

depends on many factors, conditions and variables,

including distance from the access point, volume of

network traffic, building materials and construction,

operating system used, interference and other adverse

conditions.

FCC Statement

This product has been tested and complies with the

specifications for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in

a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not

installed and used according to the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which is found by turning the equipment off and on, the

user is encouraged to try to correct the interference by

one or more of the following measures:

Reorient or relocate the receiving antenna

Increase the separation between the equipment or

devices

Connect the equipment to an outlet other than the

receiver’s

Consult a dealer or an experienced radio/TV technician

for assistance

Safety Notices

Caution: To reduce the risk of fire, use only No.26 AWG or

larger telecommunication line cord.

Do not use this product near water, for example, in a wet

basement or near a swimming pool.

Avoid using this product during an electrical storm. There

may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known

to the State of California to cause cancer, and

birth defects or other reproductive harm. Wash

hands after handling.

•

Industry Canada (Canada)

This device complies with Industry Canada ICES-003 rule.

Cet appareil est conforme à la norme NMB003 d’Industrie

Canada.

IC Statement

Operation is subject to the following two conditions:

This device may not cause interference and

This device must accept any interference, including

interference that may cause undesired operation of

the device.

Règlement d’Industry Canada

Le fonctionnement est soumis aux conditions suivantes :

Ce périphérique ne doit pas causer d’interférences;

Ce périphérique doit accepter toutes les interférences

reçues, y compris celles qui risquent d’entraîner un

fonctionnement indésirable.

FCC Caution: Any changes or modifications not

expressly approved by the party responsible for

compliance could void the user's authority to operate

this equipment.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2)

this device must accept any interference received,

including interference that may cause undesired

operation.

IMPORTANT NOTE:

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. This

equipment should be installed and operated with

minimum distance 20 cmbetween the radiator & your

body.

This transmitter must not be co-located or operating in

conjunction with any other antenna or transmitter.

The availability of some specific channels and/or

operational frequency bands are country dependent and

are firmware programmed at the factory to match the

intended destination. The firmware setting is not

accessible by the end user.

This device complies with RSS-210 of the Industry

Canada Rules.