User Manual
Table Of Contents
- User Guide
- Table of Contents
- List of Figures
- Chapter 1: Introduction
- Chapter 2: Planning your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Notebook Adapter
- Chapter 4: Software Installation and Configuration
- Chapter 5: Hardware Installation
- Chapter 6: Using the WLAN Monitor
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Windows Help
- Appendix D: Glossary
- Appendix E: Specifications
- Appendix F: Warranty Information
- Appendix G: Regulatory Information
- Appendix H: Contact Information
7
Chapter 4: Software Installation and Configuration
Wireless-G Notebook Adapter
Chapter 4: Software Installation and Configuration
The Wireless Wireless-G Notebook Adapter Setup Wizard will guide you through the installation procedure. The
Setup Wizard will install the WLAN Monitor and driver, as well as configure the Adapter.
Insert the Setup Wizard CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically, and the
Welcome screen should appear. If it does not, click the Start button and choose Run. In the field that appears,
enter D:\setup.exe (if “D” is the letter of your CD-ROM drive).
On the Welcome screen, you have the following choices:
Install - Click the Install button to begin the software installation process.
User Guide - Click the User Guide button to open the PDF file of this User Guide.
Exit - Click the Exit button to exit the Setup Wizard.
NOTE: You must run the Setup Wizard to install the software before installing
the hardware.
Figure 4-1: The Setup Wizard’s Welcome screen