User Manual

2. When Windows has finished installing the driver, click the Finish button.

You have now completed the driver installation for

the Adapter. To configure the Adapter, proceed to the next section,

“Windows XPWireless Zero Configuration.”

Figure 6-2

1. After installing the Adapter, the

Windows XP Wireless Zero

Configuration icon will appear in

your computer’s system tray (see

Figure 6-3). Double-click the icon.

2. The screen that appears will

show any available wireless

network. Select the network

you want.

If this network has a pre-

shared key encryption (WEP,

AES, TKIP) enabled, go to

step 3. If this network does

not have pre-shared key

encryption enabled, then the

screen in Figure 6-4 will

appear. Check the box next

to Allow me to connect to the

selected wireless network,

even though it is not secure.

Then click the Connect but-

ton and go to step 4.

For Windows XP users: Windows XP has a built-in configuration tool.

Use Windows XP Wireless Zero Configuration (in the system tray at

the bottom of your screen) to configure the Adapter.

Figure 6-3

Figure 6-4

Note: Steps 2 and 3 are instructions and screenshots for Windows XP

with Service Pack 1 installed. If you have not installed Service Pack

1, select the network you want, and click the Connect button. If the

network has WEP encryption enabled, enter the WEP key in the

Network key field, and then click the Connect button.

Windows XP Wireless Zero Configuration