User Manual
Table Of Contents
- Copyright and Trademarks
- How to Use this Guide
- Chapter 1: Introduction
- Chapter 2: Getting to Know the Wireless-G IP Phone
- Chapter 3: Installing and Using the Wireless-G IP Phone
- Chapter 4: Configuring the Wireless-G IP Phone
- Chapter 5: Using the Web-Based Utility
- Appendix A: Troubleshooting
- Appendix B: Glossary
- Appendix C: Specifications
- Appendix D: Warranty Information
- Appendix E: Regulatory Information
- Appendix F: Contact Information
Wireless-G IP Phone
36
Chapter 5: Using the Web-Based Utility
How to access the web-based utility
3. You will see the Wi-Fi Phone login screen. Enter the IP Phone’s Username and Password. Click
Submit. You will log in to the Status screen and can select any of the tabs to add or change phone
setting information.
The default User Name is admin and the Admin password is admin, but may change if you have
an ITSP.
Status
Click the Status tab to view the IP phone’s IP address, Mac address, ESSID and BSSID.
Note: To make a selection or confirm an entry, you must click on the option at the
bottom of the screen. Pressing the Enter key will not confirm your selection(s).
Figure 5-1: Wireless Network Status