User's Manual Part 1
Table Of Contents
- User Guide
- Chapter 1: Introduction
- Chapter 2: Planning Your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Ethernet Bridge
- Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup
- Chapter 5: Setting Up the Wireless-G Ethernet Bridge
- Chapter 6: Connecting the Wireless-G Ethernet Bridge for Network Use
- Chapter 7: Using the Wireless-G Ethernet Bridge Web-based Utility
8
Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup
Wireless-G Ethernet Bridge
Chapter 4: Connecting the Wireless-G Ethernet Bridge for
Setup
1. Attach the Bridge’s antenna.
2. Plug the included Ethernet network cable into the LAN port on the back panel of the Bridge, shown in Figure
4-1.
3. Plug the other end of the Ethernet network cable into the RJ-45 port of the hub, switch, or PC you wish to use
to configure the Bridge.
4. Plug the supplied power cable into the Power port on the back panel of the Bridge, shown in Figure 4-2. Then
plug the other end into an electrical outlet.
Proceed to “Chapter 5: Setting Up the Wireless-G Ethernet Bridge.”