User's Manual Part 1
Table Of Contents
- User Guide
- Chapter 1: Introduction
- Chapter 2: Planning Your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Ethernet Bridge
- Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup
- Chapter 5: Setting Up the Wireless-G Ethernet Bridge
- Chapter 6: Connecting the Wireless-G Ethernet Bridge for Network Use
- Chapter 7: Using the Wireless-G Ethernet Bridge Web-based Utility
7
Chapter 3: Getting to Know the Wireless-G Ethernet Bridge
The Front Panel
Wireless-G Ethernet Bridge
The Front Panel
The LEDs indicate network activity experienced by the Bridge. (See Figure 3-2.)
Power Green. The Power LED will light up when the Bridge is powered on. While the Bridge is booting
up and performing a self-test, the Power LED will flash. It will stop flashing and remain lit
when the self-test has ended.
Ethernet Green. The Ethernet LED will be lit steadily when the Bridge is connected to the wired network.
The LED will flash when there is wired network traffic.
Wireless-G Green. The Wireless-G LED will be lit steadily when the Bridge is connected to the wireless
network. The LED will flash when there is wireless network traffic.