User's Manual

Wireless Ethernet Bridge
3
Instant Wireless
®
Series
2
PWR Green. The PWR LED will light up when
the Bridge is powered on.
DIAG Green. The DIAG LED will light up when
there is a connection error. Re-establish the
connection to eliminate the error.
LAN Green. The LAN LED will be lit steadily
when the Bridge is connected to the LAN.
The LED will blink when there is LAN traf-
fic.
WLAN Green. The WLAN LED indicates the status
of the link to the wireless local area network
(WLAN). The WLAN LED will be lit
steadily when the Bridge is connected to the
WLAN. The LED will blink when there is
WLAN traffic.
F i gu r e 2 - 2
Chapter 2: Getting to Know the
Wireless Ethernet Bridge
Reset The Reset button resets the Bridge to its factory default set-
tings.
X - II The X-II selection switch offers a choice between two set-
tings. Use the X setting if you are connecting the Bridge to a
network card or other Ethernet device. Use the II setting if
you are connecting the Bridge to a hub or switch.
LAN The LAN port is where you will connect your Ethernet net-
work cable.
Power The Power port is where you will connect your power.
F i gu r e 2 - 1
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user authority to operate the equipment.
T he .W ireless .E thernet .B ridge ' s ..F ront
P anel .LED s
T he .W ireless .E thernet .B ridge ' s ..B ack .P anel