User's Guide
Table Of Contents
- User Guide Cover
- Chapter 1: Introduction
- Chapter 2: Getting to Know the Wireless-G CompactFlash Card
- Chapter 3: Setting Up the PDA
- Chapter 4: Installing the CompactFlash Card
- Chapter 5: Connecting to a Wireless Network
- Chapter 6: Configuring the Wireless-G CompactFlash Card with the Wireless Network Monitor
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Upgrading Firmware
- Appendix D: Windows Help
- Appendix E: Glossary
- Appendix F: Specifications
- Appendix G: Warranty Information
- Appendix H: Regulatory Information
- Appendix I: Contact Information
15
Chapter 5: Connecting to a Wireless Network
Connect to a Wireless Network
Wireless-G CompactFlash Card
5. Power Management is a power saving mode. To enable Power Management, select On. To disable Power
Management, select Off. Then, click Finish.
6. You will return to the
Select Profile screen. Click OK.
The installation of the Wireless-G CompactFlash Card is complete.
Figure 5-11: Power Management
Figure 5-12: Select Profile