User's Guide
Table Of Contents
- User Guide Cover
- Chapter 1: Introduction
- Chapter 2: Getting to Know the Wireless-G CompactFlash Card
- Chapter 3: Setting Up the PDA
- Chapter 4: Installing the CompactFlash Card
- Chapter 5: Connecting to a Wireless Network
- Chapter 6: Configuring the Wireless-G CompactFlash Card with the Wireless Network Monitor
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Upgrading Firmware
- Appendix D: Windows Help
- Appendix E: Glossary
- Appendix F: Specifications
- Appendix G: Warranty Information
- Appendix H: Regulatory Information
- Appendix I: Contact Information
5
Chapter 3: Setting Up the PDA
Overview
Wireless-G CompactFlash Card
Chapter 3: Setting Up the PDA
Overview
This Setup Wizard will take you through all the steps necessary to install the Card’s software on your PC so it can
communicate with the PDA.
Connect your PDA to your PC. Make sure you have the Microsoft ActiveSync software installed on your PC. Refer
to your PDA’s documentation for information on Microsoft ActiveSync software.
Setup Wizard
1. Insert the Setup Wizard CD into your PC's CD-ROM drive.
2. The Setup Wizard's Welcome screen should appear on your monitor. (If it does not, the autorun is not
functioning. Start the Setup Wizard manually by clicking the Start button, selecting Run, and typing
d:\setup.exe (where "D" is your PC's CD-ROM drive)).
Click the Install button to continue this Setup Wizard. Clicking the User Guide button opened this Guide. To
exit this Setup Wizard, click the Exit button.
3. The following screen displays the License Agreement. Read the agreement, then if you agree, click Next to
continue.
Click Cancel to return to the previous screen.
Figure 3-3: License Agreement
Figure 3-1: PDA to PC Installation
Figure 3-2: Welcome