User's Manual

10
Chapter 5: Setting Up the Wireless-G Access Point with Power Over Ethernet
Setup Wizard
Wireless-G Access Point with Power Over Ethernet
Chapter 5: Setting Up the Wireless-G Access Point with Power
Over Ethernet
Setup Wizard
Now that you've connected the Access Point to your wired network, you are ready to begin setting it up. This
Setup Wizard will take you through all the steps necessary to configure the Access Point.
1. Insert the Setup Wizard CD into your PC's CD-ROM drive. Your PC must be on your wired network to set up the
Access Point.
2. The Setup Wizard's Welcome screen should appear on your monitor. If it does not, then click the Start button
and select Run. In the field provided, enter D:\setup.exe (if “D” is the letter of your PC's CD-ROM drive).
Click the Click Here to Start or Setup button to proceed with this Setup Wizard. Clicking the User Guide
button opened this Guide. To exit this Setup Wizard, click the Exit button.
Figure 5-1: Setup Wizard’s Welcome Screen