User's Manual

18
Chapter 5: Setting Up the Wireless-G Access Point with Power Over Ethernet
Setup Wizard
Wireless-G Access Point with Power Over Ethernet
13. On the Confirmation screen, make sure your new settings for the Main SSID are correct. Click the SSID1 and
SSID2 radio buttons to view their settings. To save your new settings, click the Yes button. If you do not want
to save your changes, then click the No button.
14. At this point, the configuration performed with the Setup Wizard is complete. To configure any other Access
Points in your network, you can run this Setup Wizard again.
Click the Online Registration button to register the Access Point, or click the Exit button to exit the Setup
Wizard.
For more advanced configuration, you can go to “Chapter 6: Configuring the Wireless-G Access Point
with Power Over Ethernet.”
Figure 5-13: Confirmation Screen
Figure 5-14: Congratulations Screen