Quick Start Manual
For additional information or troubleshooting help, refer to the User Guide on the CD-ROM.
Additional support is also available by phone or online.
Website
http://www.linksys.com/international
Australia
http://www.linksys.com/au/registration
Product Registration
United Kingdom
http://www.linksys.com/uk/registration
New Zealand
http://www.linksys.com/nz/registration
Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2008
Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.
RFC 1483 Bridged - Static IP Address
1. For the IP Setting, select Use
the Following IP Address.
Enter the IP Address, Subnet 2.
Mask, and Default Gateway IP
address.
In the3. Primary and/or
Secondary DNS elds, enter at
least one DNS IP address.
Click 4. Save Settings.
Bridge Mode Only
Use this mode only if you are
using the Gateway as a bridge,
which makes the Gateway act
like a stand-alone modem. Click
Save Settings.
In the web browser’s G. Address field, enter the appropriate website:
www.linksys.com/uk/registration (United Kingdom),
www.linksys.com/au/registration (Australia), or
www.linksys.com/nz/registration (New Zealand). Then press Enter.
NOTE FOR WIRELESS GATEWAYS: Refer to the User Guide
on the CD-ROM for instructions on wireless conguration.
Linksys recommends that you change the default wireless
settings and enable the appropriate security method.
Congratulations! The installation of the Gateway is complete.
RFC 1483 Bridged - Static IP Address
Bridge Mode Only
8031010NC-RR