Quick Start Manual
2
English
Installation1
NOTE:
Run the Setup CD-ROM to install the Modem Router. If you
cannot run the Setup CD-ROM, refer to this Quick Installation Guide.
Power down all your network devices, including your computer(s) 1.
and the Modem Router. If you currently use a modem, disconnect it
now—the Modem Router replaces your modem.
2. Connect one end of the
provided Ethernet cable to
your computer’s Ethernet
adapter and the other end to an
Ethernet port on the back of the
Modem Router.
Repeat step 2 for each additional computer or device that you want to 3.
connect to the Modem Router.
NOTE: If your computer’s Ethernet adapter is not set up, refer to
the Ethernet adapter’s documentation for more information.
4. Connect one end of the phone
cable to the DSL port on the back.
Connect the other end of the 5.
phone cable to the wall jack
with ADSL service or microfilter.
NOTE: If you experience static on your phone line, you may need
a microlter or splitter. (This is required for users in the UK; other
users should contact their ISPs to verify. ISDN users do not need
a microlter.) If you require a microlter, you must install one for
each phone or fax that you use. To install a microlter, plug it into
a phone jack that has ADSL service, then connect one end of the
provided phone cable to the microlter’s DSL port.
Connect the Computer
Connect the DSL