Owner's Manual

24
Chapter 3: Advanced Configuration
User Guide
RADIUS
NOTE: If you select RADIUS as your Security
Mode, each device in your wireless network
MUST use RADIUS and the same WEP encryption
and shared key.
Security Mode > RADIUS
RADIUS Server Enter the IP Address of the RADIUS server.
RADIUS Port Enter the port number of the RADIUS
server. The default value is 1812.
Shared Secret Enter the key shared between the Valet
and the server.
Encryption Select a level of WEP encryption, 40/64bits
(10 hex digits) or 104/128 bits (26 hex digits). The
default is 40/64 bits (10 hex digits).
Passphrase Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 2 If you did not enter a Passphrase, enter the WEP
key manually.
Disabled
NOTE: When wireless security is disabled,
anyone can access your wireless network at any
time.
Security Mode > Disabled
If you choose to disable wireless security, you will be
informed that wireless security is disabled when you
first attempt to access the Internet. You will be given the
option to enable wireless security, or confirm that you
understand the risks but still wish to proceed without
wireless security.
Wireless > Wireless MAC Filter
The Wireless MAC Filter option allows you to block or grant
access to your network based on the device’s MAC address.
Each device on your network has a unique MAC address that
was assigned to it by the manufacturer.
Wireless > Wireless MAC Filter
Wireless MAC Filter
Enabled/Disabled To filter wireless users by MAC Address,
either permitting or blocking access, select Enabled. If you
do not wish to filter users by MAC Address, keep the default
setting, Disabled .
Prevent Select this option to block a specific device or
multiple devices from accessing your wireless network.
You can manually enter the unwanted MAC address(es)
or select the device(s) from the Wireless Client List. When
wireless MAC filtering is enabled, this option is selected
by default.
Permit Select this option to specify which devices can
access your wireless network. When this option is enabled,
only devices that have their MAC address listed in the
Wireless MAC Filter list will be able to access your wireless
network. You can enter MAC addresses manually or select
them from the Wireless Client List.