0/100/1000 Gigabit Switches Use this guide to install the following products: SD2005 SD2008 5-Port 10/100/1000 Gigabit Switch 8-Port 10/100/1000 Gigabit Switch User Guide
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2003 Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.
Table of Contents Chapter 1: Introduction Chapter 1: Introduction The 10/100/1000 Gigabit Switch Features 1 1 1 Chapter 2: Getting to Know the 10/100/1000 Gigabit Switch Overview Front Panel LEDs Back and Side Panel Features 2 2 2 2 Chapter 3: Connecting the 10/100/1000 Gigabit Switch Overview Connecting Network Devices Placement Options 4 4 5 6 Appendix A: Glossary 7 Appendix B: Specifications Environmental 9 9 Appendix C: Warranty Information 10 Appendix D: Contact Information 11 The 10/10
Chapter 2: Getting to Know the 10/100/1000 Gigabit Switch Overview The 5- and 8-Port 10/100/1000 Gigabit Switches differ in number of LEDs and ports. Pictured here is the 5-Port Switch; however, the other Switch is similar in form. Front Panel LEDs Figure 2-3 The power port is located on the side panel of the Switch (see Figure 2-3). (power) The power port is where you will connect the included power adapter. Figure 2-1 System Green. The System LED will light up when the Switch is powered on.
Chapter 3: Connecting the 10/100/1000 Gigabit Switch Connecting Network Devices To connect network devices to the Switch, follow these instructions. 1. Make sure all the devices you will connect to the Switch are powered off. Overview This chapter will explain how to connect network devices to the Switch. For an example of a typical network configuration, see the application diagram shown in Figure 3-1. 2. Connect a Category 5 Ethernet network cable to one of the numbered ports on the Switch.
Appendix A: Glossary Placement Options Set the Switch on its four rubber feet, or hang the Switch on a wall using its wall-mount slots. To use the wall-mount option, follow these instructions: 1. The wall-mount slots are two crisscross slots on the Switch’s bottom panel, as shown in Figure 3-4. Attach two screws to the wall, so that the Switch’s wall-mount slots line up with the two screws. 10BaseT - An Ethernet standard that uses twisted wire pairs.
Fast Ethernet - A 100 Mbps technology based on the 10Base-T Ethernet CSMA/CD network access method. Appendix B: Specifications Hub - The device that serves as the central location for attaching wires from workstations. Can be passive, where there is no amplification of the signals; or active, where the hubs are used like repeaters to provide an extension of the cable that connects to a workstation.
Appendix C: Warranty Information Appendix D: Contact Information BE SURE TO HAVE YOUR PROOF OF PURCHASE AND A BARCODE FROM THE PRODUCT’S PACKAGING ON HAND WHEN CALLING. RETURN REQUESTS CANNOT BE PROCESSED WITHOUT PROOF OF PURCHASE. For help with the installation or operation of this 10/100/1000 Gigabit Switch, contact Linksys Technical Support at one of the phone numbers or Internet addresses below.
http://www.linksys.com © Copyright 2003 Cisco Systems, Inc. All Rights Reserved.
