Owner's Manual

30
Session ID
A number identifying the mirror session. This Switch only supports
up to 4 mirror sessions.
Destination Port
Select the port for traffic purposes from source ports mirrored to
this port.
Source TX/RX Port
Sets the source port from which traffic will be mirrored.
TX Port: Only frames transmitted from this port are mirrored to the
destination port.
RX Port: Only frames received on this port are mirrored to the
destination port.
Both: Frames received and transmitted on this port are mirrored to
the specified destination port.
None: Disables mirroring for this port.
Ingress State
Select whether to enable or disable ingress traffic forwarding.
Session State
Select whether to enable or disable port mirroring.
Note: You cannot mirror a faster port onto a slower port. For example, if you try to mirror the
traffic from a 100Mbps port onto a 10Mbps port, this can cause throughput problems. The
port you are copying frames from should always support an equal or lower speed than the
port to which you are sending the copies. Please note a target port and a source port cannot
be the same port.
Click the button to modify specific mirror entry.
Click the Apply button to accept the changes or the Cancel button to discard them.