User manual

CHAPTER 2 Access Point Setup
Linksys
24
Workgroup Bridge
Radio Select the desired radio from the list.
Workgroup Bridge Status
Status Enable or disable Workgroup Bridge function.
Workgroup Bridge can only be enabled when
VLAN function is disabled.
Before configuring Workgroup Bridge, make
sure all devices in Workgroup Bridge have
the following identical settings.
• Radio
• IEEE 802.11 Mode
• Channel Bandwidth
• Channel (Auto is not recommended)
Infrastructure Client Interface
SSID Enter the name of the SSID to which
Workgroup Bridge will connect. Click Site
Survey button to choose from the list.
Workgroup Bridge must connect to a remote
access point.
Remote MAC Address Normally, Workgroup Bridge connects to a
remote access point by matching SSID. When
multiple remote access points have the
same SSID,Workgroup Bridge can connect to
different remote access points.
Optional: You can specify the MAC address of
the remote access point to limit Workgroup
Bridge’s connection to a specific remote
access point.The format is xx:xx:xx:xx:xx:xx.
Security Mode Select the desired mode from the list.
• Disabled
• WPA-Personal
• WPA2-Personal
Advanced Settings
Configure advanced parameters of the wireless radios.
Figure 31: Advanced Settings