User manual

CHAPTER 2 Access Point Setup
Linksys
12
Authentication This feature supports following two kinds of
authentication:
• Authentication via MAC Address
Select this if you want to use MAC address for
authentication.
The access point uses lowercase MAC address for Name
and Password, like xxxxxxxxxxxx.
• Authentication via Name and Password
Select this if you want to use name and password for
authentication.
Name - Enter the login name. The name includes 1 to 63
characters. Special characters are allowed.
Password - Enter the desired login password. The
password includes 4 to 63 characters. Special characters
are allowed.
Discovery Settings
Bonjour Enable if administrator wants the access point to be
discovered by Bonjour enabled devices automatically.
If VLAN is enabled, the discovery packets will be sent
out via management VLAN only. The access point
supports http and https services.
LLDP Enable if administrator wants the access point to be
discovered by switch by LLDP protocol. Information
such as product name, device name, firmware version,
IP address, MAC address and so on will be advertised.
LLDP-MED Enable if administrator wants the access point to
be discovered by switch by LLDP-MED protocol.
Information such as product name, device name,
firmware version, IP address, MAC address and so on
will be advertised.
Basic Settings
Basic Settings provides the essential configuration for your wireless radio and
SSIDs. You should be able to set up your wireless network with these essential
parameters configured. Advanced wireless settings such as Band Steering,
Channel Bandwidth, etc., will be on Configuration → Wireless → Advanced
Settings screen.
Click Basic Settings on the Wireless menu.
Figure 16: Basic Settings Screen