User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
96
System Status
Status
System Summary
Go to System Status > Status > System Summary for status of the access point.
System Summary
Device SKU
The SKU is often used to identify device model number
and region.
Firmware Version
The version of the firmware currently installed.
Firmware
Checksum
The checksum of the firmware running in the access
point.
Hardware Version
The version of the hardware.
Local MAC
Address
The MAC (physical) address of the wireless access
point.
Serial Number
The serial number of the device.