User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
87
Terms of Use
Customize the text to go with Terms of Use. Enter up
to 512 characters. The default is "Terms of Use".
Success Text
Customize the text that shows when the client has
been authenticated. The default is "You have logged
on successfully! Please keep this window open when
using the wireless network."
Failure Text
Customize the text that shows when authentication
fails. Enter up to 128 characters. The default is "Bad
username or password"
Profile Association
Go to Configuration > Captive Portal > Profile Association to associate defined Captive Portal
profiles with SSIDs.