User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
69
WDS
Go to Configuration > Wireless > WDS (Wireless Distribution System) to expand a wireless
network through multiple access points instead of linking them with a wired backbone.
The access point can act as WDS Root or WDS Station:
•
WDS Root - Receives WDS connections from remote WDS Stations.
•
WDS Station - Connects to remote WDS Root. Supports up to 4 WDS Stations on each
wireless radio.