User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
65
SSID
Select the desired SSID from the list.
Control Type
Select the option from the drop-down list as desired.
•
Local: Choose either “Allow only following MAC
addresses to connect to wireless network” or
“Prevent following MAC addresses from connection
to wireless network.” You can enter up to 20 MAC
addresses of wireless stations or choose the MAC
address.
•
RADIUS
Primary/Backup RADIUS Server - Enter the IP
address of the RADIUS Server.
Primary/Backup RADIUS Server Port – Enter the
Port
number of the RADIUS Server.
Primary/Backup Shared Secret - This is shared
between the wireless access point and the RADIUS
Server while
authenticating the device attempting to connect.
•
Disabled