User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
61
Scheduler
Go to Configuration > Wireless > Scheduler to configure a rule with a specific time interval for
SSIDs to be operational. Automate enabling or disabling SSIDs based on the profile definition.
Support up to 16 profiles and each profile can include four time rules.
Scheduler
Wireless
Scheduler
Enable or disable wireless scheduler on the radio. It is
disabled by default.
If disabled, even if some SSIDs are associated with
profiles, they will be always active.