User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
45
Duplex Mode
Select the duplex mode of the ethernet port. Available only when
Auto Negotiation is disabled. The option can be Half or Full (default).
Operational
Duplex Mode
Displays the current duplex mode of the ethernet port.
Flow Control
Enable or disable flow control of the ethernet port.
802.1x Supplicant
802.1x
Supplicant
Enable if your network requires this access point to use 802.1X
authentication in order to operate.
Authentication
This feature supports following two kinds of authentication:
•
Authentication via MAC Address
Select this if you want to use MAC Address for authentication.
The access point uses lowercase MAC address for Name and
Password, like xxxxxxxxxxxx.
•
Authentication via Name and Password
Select this if you want to use name and password for
authentication.
Name - Enter the login name. The name includes 1 to 63
characters. Special characters are allowed.
Password - Enter the desired login password. The password
includes 4 to 63 characters. Special characters are allowed.
Discovery Settings
Bonjour
Enable if administrator wants the access point to be discovered by
Bonjour enabled devices automatically. If VLAN is enabled, the
discovery packets will be sent out via management VLAN only. The
access point supports http and https services.
LLDP
Enable if administrator wants the access point to be discovered by
switch by LLDP protocol. Information such as product name, device
name, firmware version, IP address, MAC address and so on will be
advertised.
LLDP-MED
Enable if administrator wants the access point to be discovered by
switch by LLDP-MED protocol. Information such as product name,
device name, firmware version, IP address, MAC address and so on
will be advertised.