User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
44
Advanced
Go to Configuration > LAN > Advanced this screen to configure advanced network settings of the
access point.
Port Settings
Auto
Negotiation
If enabled, Port Speed and Duplex Mode will become grey and cannot
be configured. If disabled, Port Speed and Duplex Mode can be
configured.
Operational
Auto
Negotiation
Current Auto Negotiation mode of the ethernet port.
Port Speed
Select the speed of the ethernet port. Available only when Auto
Negotiation is disabled. The option can be 10M, 100M or 1000M
(default).
Operational
Port Speed
Displays the current port speed of the ethernet port.