User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
40
SSL Certificate
Go to Configuration > Administration and select SSL Certificate to manage the SSL certificate
used by HTTPS.
Export/Restore to/from Local PC
Export SSL
Certificate
Click to export the SSL certificate.
Install Certificate
Browse to choose the certificate file. Click
Install Certificate.
Export to TFTP Server
Destination File
Enter the name of the destination file.
TFTP Server
Enter the IP address for the TFTP server. Only support IPv4
address here.
Export
Click to export the SSL certificate to the TFTP server.