User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
36
Username
Enter the Username to login to your SMTP server.
The Username can include up to 32 characters. Special characters
are allowed.
Password
Enter the Password to login to your SMTP server.
The Password can include up to 32 characters. Special characters
are allowed.
Email Address for
Logs
Enter the email address the log messages are to be sent to.
Valid characters include alphanumeric characters, "_", "-", "." and "@".
Maximum length is 64 characters.
Log Queue Length
Enter the length of the queue: up to 500 log messages. The default is
20 messages. When messages reach the set length the queue will be
sent to the specified email address.
Log Time
Threshold
Enter the time threshold (in seconds) used to check if the queue is
full. It’s a value from 1 to 600 and default is 600 seconds.
Syslog
Syslog Notification
Enable Syslog notification.
IP Type
Select the IP type of the syslog server: IPv4 or IPv6.
Server IP Address
Enter the IPv4 or IPv6 address of syslog server here.