User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
17
General
Wireless Name—Choose a name and decide whether to broadcast or hide that name.
Authentication—Choose whether to protect the wireless name with a password or allow all
devices to connect. If using a password, choose a security type - either WEP or WPA2.
Status—Enable or disable the wireless name. Disabled wireless names will not be broadcast.
Delete wireless name—Remove the wireless name and all settings from the cloud.
Be sure to click the Save button when you are finished making changes.
Broadcasting
Choose whether to broadcast the wireless names available on an access point.