User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
14
TCP/IP
Configure IP—Select Automatic Configuration or Static IP Address.
Server IP—Enter an unused IP address from the address range used on your LAN.
Gateway—Enter the gateway for IP Server.
Subnet mask—Enter the subnet mask for the IP address.
Primary DNS server—Enter the DNS Address.
Secondary DNS server—Optional.
VLAN Tagging—Enter tag of your VLAN.
Radio
Radio mode—Choose a radio mode
Channel width --Choose 20 MHz, 40 MHz or 80 MHz
Channel—Choose Auto or a channel from 1-5
TX Power—Choose the strength of signal when access point is transmitting