User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
13
Details
View whether the access point is connected to the cloud. See the current firmware version and
check for updates. You can also see the MAC address, model number, the name you gave it and
any device notes or description.
Wireless slot
To add a new wireless name to the device, click Add wireless name and select one from the list.
Authentication—Shows whether the wireless name is open or requires a password.
Broadcast—Shows how many access points in the network are broadcasting the wireless name.
Splash page—Shows whether a splash page is enabled or disabled.
Bandwidth limit—Shows the bandwidth limit set by the administrator.