User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
127
Internet Authentication Service (RADIUS) Setup
1.
Select Start > Programs > Administrative Tools > Internet Authentication Service.
2.
Right-click on Clients and select New Client.
3.
Enter a name for the access point, click Next.
4.
Enter the address or name of the wireless access point, and set the shared secret, as
entered on the Security Settings of the wireless access point.
5.
Click Finish.
6.
Right-click on
Remote Access Policies
, select
New Remote Access Policy
.
7.
Assuming you are using EAP-TLS, name the policy “eap-tls”, and click Next.
8.
Click Add...
If you don't want to set any restrictions and a condition is required, select
Day-And-Time-
Restrictions
, and click Add...