User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
126
7.
Select Computer Configuration > Windows Settings > Security Settings > Public Key
Policies, right-click Automatic Certificate Request Settings > New > Automatic
Certificate Request.
8.
When the Certificate Request Wizard appears, click Next.
9.
Select Computer, click Next.
10.
Ensure that your Certificate Authority is checked, click Next.
11.
Review the policy change information and click Finish.
12.
Click
Start
>
Run
, type “cmd
”
and press Enter. Enter “secedit /refreshpolicy
machine_policy”. This command may take a few minutes to take effect.