User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
124
12.
Select Yes, I want to activate this scope now. Click Next, then Finish.
13.
Right-click on the server and select Authorize. It may take a few minutes to complete.
Certificate Authority Setup
1.
Select Start > Programs > Administrative Tools > Certification Authority.
2.
Right-click Policy Settings and select New > Certificate to Issue.
3.
Select Authenticated Session and Smartcard Logon (select more than one by holding
down the Ctrl key). Click OK.
4.
Select Start > Programs > Administrative Tools > Active Directory Users and Computers.