User Guide
Table Of Contents
- Package Contents
- Access Point Setup Guide
- Setup to manage your access point with Linksys cloud server
- Step 1
- Make sure the access point is powered on and connected with an ethernet cable to your network with internet access. By factory default, the IP address is assigned by a DHCP server. If there is no DHCP server in your network, the default IP address is ...
- Log in to the access point’s browser-based admin tool locally and click the Configure LAN Settings link. Change the IP address or VLAN so the access point can access the internet.
- If the indicator light is off, check that the AC power adapter, or PoE cable, is properly connected on both ends.
- Step 2
- Setup to manage your access point locally with browser-based admin tool
- Setup to manage your access point with Linksys cloud server
- Cloud Management Interface
- Local Management Interface
- Appendix A - Troubleshooting
- Appendix B - About Wireless LANs
- Appendix C - PC and Server Configuration
122
6.
Enter the information for the Certificate Authority and click Next.
7.
Click Next if you don't want to change the CA's configuration data.
8.
Installation will warn you that Internet Information Services are running, and must be
stopped before continuing. Click OK, then Finish.
DHCP server configuration
1.
Click on Start > Programs > Administrative Tools > DHCP.
2.
Right-click on the server entry and select New Scope.
3.
Click Next when the New Scope Wizard Begins.