User manual
Table Of Contents

CHAPTER 2 Access Point Setup
Linksys
6
Data - User Accounts Screen
User Account Table
User Name Enter the User Name to connect to the access
point’s admin interface. User Name is effective
once you save settings.
User Name can include up to 63 characters. Special
characters are allowed.
User Level Only administrator account has Read/Write
permission to the access point’s admin interface.
All other accounts have Read Only permission.
New Password Enter the Password to connect to the access point’s
admin interface.
Password must be between 4 and 63 characters.
Special characters are allowed.
Confirm New Password Re-enter password.
Time Screen
Click Time on the Administration menu to configure system time of the device.
Figure 10: Time Screen
Data - Time Screen
Time
Current Time Display current date and time of the system.
Manually Set date and time manually.
Automatically When enabled (default setting) the access point will get the
current time from a public time server.
Time Zone Choose the time zone for your location from the drop-down
list. If your location observes daylight saving time, enable
“Automatically adjust clock for daylight saving changes.”
Start Time Specify the start time of daylight saving.
End Time Specify the end time of daylight saving.
Offset Select the adjusted time of daylight saving.
NTP
NTP Server 1 Enter the primary NTP server. It can be an IPv4 address or a
domain name.
Valid characters include alphanumeric characters, “_”, “-”
and “.”. Maximum length is 64 characters.
NTP Server 2 Enter the secondary NTP server. It can be an IPv4 address or
a domain name.
Valid characters include alphanumeric characters, “_”, “-”
and “.”. Maximum length is 64 characters.