User manual

CHAPTER 2 Access Point Setup
Linksys
12
Discovery Settings
Bonjour Enable if administrator wants the access point to be
discovered by Bonjour enabled devices automatically. If
VLAN is enabled, the discovery packets will be sent out via
management VLAN only. The access point supports http
and https services.
LLDP Enable if administrator wants the access point to be
discovered by switch by LLDP protocol. Information such as
product name, device name, firmware version, IP address,
MAC address and so on will be advertised.
LLDP-MED Enable if administrator wants the access point to be
discovered by switch by LLDP-MED protocol. Information
such as product name, device name, firmware version, IP
address, MAC address and so on will be advertised.
Wireless Screens
There are ten configuration screens:
• BasicSettings
• Security
• RogueAPDetection
• Scheduler
• SchedulerAssociation
• ConnectionControl
• RateLimit
• QoS
• WorkgroupBridge
• AdvancedSettings
Basic Settings
Basic Settings provides the essential configuration for your wireless radio and
SSIDs. You should be able to set up your wireless network with these essential
parameters configured. Advanced wireless settings such as Band Steering,
Channel Bandwidth, etc., will be on Configuration Wireless Advanced
Settings screen.
Click Basic Settings on the Wireless menu.
Figure 16: Basic Settings Screen