User manual

CHAPTER 2 Access Point Setup
Linksys
9
SSL Certificate
This screen can be used to manage SSL certificate used by HTTPS.
Figure 13: SSL Certificate Screen
Location Enter the area or location where the access point
resides.
The location includes 1 to 32 characters. Special
characters are allowed.
SNMPv1/v2 Settings
Get Community Enter the name of Get Community. Get Community
is used to read data from the access point and not
for writing data into the access point.
Get Community includes 1 to 32 characters. Special
characters are allowed.
Set Community Enter the name of Set Community. Set Community
is used to write data into the access point.
The Set Community includes 1 to 32 characters.
Special characters are allowed.
SNMPv3 Settings
SNMPv3 Settings Configure the SNMPv3 settings if you want to use
SNMPv3.
Username: Enter the username. It includes 0 to 32
characters. Special characters are allowed.
Authentication Protocol: None or HMAC-MD5.
Authentication Key: 8 to 32 characters. Special
characters are allowed.
Privacy Protocol: None or CBC-DES.
Privacy Key: 8 to 32 characters. Special characters
are allowed.
Access Control
Access Control When SNMP is enabled, any IP address can connect
to the access point’s admin page through SNMP.
You can enable access control to allow specified IP
addresses. Two IPv4 and two IPv6 addresses can be
specified.
SNMP Trap
Trap Community Enter the Trap Community server. It includes 1 to 32
characters. Special characters are allowed.
Trap Destination Two Trap Community servers are supported: can be
IPv4 or IPv6.