User's Manual
Table Of Contents
- User Guide
- Chapter 1: Introduction
- Chapter 2: Planning your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Access Point
- Chapter 4: Connecting the Wireless-G Access Point
- Chapter 5: Setting Up the Wireless-G Access Point
- Chapter 6: Linksys Wireless Guard
- Chapter 7: Configuring the Wireless-G Access Point
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Upgrading Firmware
- Appendix D: Windows Help
- Appendix E: Glossary
- Appendix F: Specifications
- Appendix G: Warranty Information
- Appendix H: Regulatory Information
- Appendix I: Contact Information
Wireless-G Access Point
Log
To view a log of the Access Point’s activity, select the Log tab.
To enable permanent logging activity, select Enable. The default setting for this function is Disable.
If you have chosen to monitor the Access Point’s traffic, then you can designate a PC that will receive permanent
log files periodically. In the Send Log to field, enter the IP address of this PC. To view these permanent logs, you
must use Logviewer software, which can be downloaded free of charge from www.linksys.com.
Figure 7-12: The Log screen
To see a temporary log of the Access Point’s most recent activities, click the View Log button.
Click the Save Changes button to apply your changes or Cancel Changes to cancel your changes. If you require
online help, click the Help button.
Chapter 7: Configuring the Wireless-G Access Point
The Setup Tab
39