User's Manual
Table Of Contents
- User Guide
- Chapter 1: Introduction
- Chapter 2: Planning your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Access Point
- Chapter 4: Connecting the Wireless-G Access Point
- Chapter 5: Setting Up the Wireless-G Access Point
- Chapter 6: Linksys Wireless Guard
- Chapter 7: Configuring the Wireless-G Access Point
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Upgrading Firmware
- Appendix D: Windows Help
- Appendix E: Glossary
- Appendix F: Specifications
- Appendix G: Warranty Information
- Appendix H: Regulatory Information
- Appendix I: Contact Information
Wireless-G Access Point
Add a Member
To add a member, follow instructions for Add a Guest, steps 1 through 3 above, except in step 3, click Add
Member.
The screen in Figure 6-14 will appear. Registered members can enter their Email address in the field and select
the duration for access from the drop-down menu. If you want this network member to have the authority to put
the network into Fallback Mode in case network security is lost, select Permission to Initiate Network
Fallback. When finished, click Submit.
To register as a member for Linksys Wireless Guard, refer to the following instructions, then when finished with
registration, return to this screen.
The member will need to install the Linksys Wireless Guard Client software on his PC. The software can be
downloaded from the Setup CD-ROM or from Linksys.com/support. Refer to
Client Software Installation at the
Figure 6-14: Add Member
beginning of this chapter.
Member Registration
1. Right-click on the green Wireless Guard Network key icon, then click Register Member.
2. The Welcome screen will appear. Click Next.
Figure 6-15: Welcome
Chapter 6: Linksys Wireless Guard
Your Account
25