User's Manual
Table Of Contents
- User Guide
- Chapter 1: Introduction
- Chapter 2: Planning your Wireless Network
- Chapter 3: Getting to Know the Wireless-G Access Point
- Chapter 4: Connecting the Wireless-G Access Point
- Chapter 5: Setting Up the Wireless-G Access Point
- Chapter 6: Linksys Wireless Guard
- Chapter 7: Configuring the Wireless-G Access Point
- Appendix A: Troubleshooting
- Appendix B: Wireless Security
- Appendix C: Upgrading Firmware
- Appendix D: Windows Help
- Appendix E: Glossary
- Appendix F: Specifications
- Appendix G: Warranty Information
- Appendix H: Regulatory Information
- Appendix I: Contact Information
Wireless-G Access Point
5. When the next screen appears, you will specify which users you will allow access to this protected network.
Enter the E-mail address, User Name, Password, then Confirm Password for each user. Then, click Add. To
remove a user from the list, select the user, then click Remove.
Figure 5-15: The Adding Authorized Users Screen
6. The Access Point is now configured for Linksys Wireless Guard. To finish configuring your wireless network,
you will need to install the Linksys Wireless Guard client software for each PC that will have access. Click
Main Menu, then click Linksys Wireless Guard Client.
To add more Access Points to your Linksys Wireless Guard network,
run the Linksys Wireless Guard Setup again for each Access Point.
Figure 5-16: The Congratulations Screen
Chapter 5: Setting Up the Wireless-G Access Point
Linksys Wireless Guard Setup
17