Linksys 5G WiFi 6 Router Quick Start Guide FGW5500 5G WiFi 6 Router 1
LED Indicators LED Indication Color Status Description Bottom LED - Blue 5G (SA/NSA) On Device connects to 5G network 5G/LTE/3G/Ethernet Green LTE/3G On Device connects to LTE/3G network Orange Ethernet WAN Device connects to Internet via Ethernet WAN Red Alarm System Alarm ON Wan/Alarm OFF Middle LED – Blue WiFi/WPS enabled Green 2 No SIM card detect • No Internet available • Failed to boot up system Power OFF On • LED ON for either 2.
On Blue Blinking Green Blinking OFF Booting LED ON for either SIP or VoLTE has been activated • While UE connects to 5G network (SA/NSA) or Ethernet WAN mode, the Voice On Top LED – Voice SIP or VoLTE enabled • LED color is Blue. • While UE connects to 4G network (LTE/3G), the Voice LED color is Green. • Blinking, SMS/Missed process.
Installation Please follow the steps below to install the router: Step1: Insert SIM card into the router with direction shown below until it clicks. Step2: Connect one of the LAN ports (any will do) on the router to your PC with a RJ-45 Ethernet cable provided. Step3: Insert the power cord into the DC-12V power jack of the router; and insert the correct plug into your home’s power outlet. Step4: Switch ON the power. The router will start the booting process.
Note: 1. To remove the SIM card, please press the card in until it clicks, and it will pop out automatically. 2. Do not remove the SIM card when the router is operating. Advanced Setup If you would like to change any of the router default settings, such as the WiFi network name SSID or Key, please access the browser on a device that is connected to the router. Step 1. Open the Web browser and enter the default IP address of FGW5500: https://192.168.15.1 Step 2.
Step 3. For more features setup, please refer to user manual on https://www.linksys.com/linksyssupport LNKPG-00978 Rev.
